1.  MINIMUM WHEEL BASE 106 INCHES.REAR WING NO TALLER THAN 4 INCHES.

2. Any American Made car allowed with Stock Wheelbase. Replacement parts must be made out of SHEET METAL, must be OEM thickness. NO ALUMINUM BODY PARTS...MUST HAVE FULL FLOOR PAN FROM FIREWALL TO TRUNK.CAN GUT TRUNK AREA.MUST HAVE STEEL FIREWALL BEHIND DRIVER.NO ENCLOSED DRIVER COMPARTMENTS.REAR BUMPERS& FRONT BUMPERS MUST HAVE ROUNDED CORNERS.NO OPEN HOLES IN FLOORPAN OR FIREWALL

3.  Must weigh 3600 LBS after race with driver's).

4.  4-Point cage mandatory!  3 door bars on  each side.  May build complete cage assembly.

5.  Both drivers must have helmetsNO OPEN FACE,MUST BE AT LEAST SNELL 95 fire suits, gloves,NECK BRACE,MANDINTORY 5 point harness and racing shoes.

6.  Remove all glass.  Doors must be securely fastened.

7.  NO MODIFICATION to SUSPENSION  MUST BE FACTORY*  OR ENGINE!!!  Must be completely stock with O.E.M. parts.  Any part that enhances performance will not be allowed.  No 400 blocks or cranks, must pull 16" of vacuum @ 1000rpm. FLAT TOP PISTONS ALLOWED NO DOMES.. Only 76 cc heads allowed, screw-in studs and guide plates OK.STOCK STYLE ROCKERS ONLY. NO PORTING OR POLISHING OF ANY TYPE. Stock intake only, no Bow-tie intake. HEI Distributor only, must be stock. NO MSD PARTS period.  Must run hydraulic cam, cubic inch rule gm,364,ford 364, dodge367. No aftermarket Harmonic balancers, must be OEM.AUTO TRANS MUST HAVE MINIMUM 11INCH CONV.3&4 SPEEDS ALLOWED ALL GEARS MUST WORK.10INCH OEMSTEEL FLYWHEEL AND CLUTCH ASSEMBLY.STEEL BELL HOUSING MANDANTORY.MAY USE HYDRAULIC SLAVE CYLINDER.MUST BE STOCK THROW OUT BEARING.

8.  Stock 500 cfm Holley only, must have STOCKchoke tower...May remove choke plate.

9.  Steering must be stock.STEEL STEERING SHAFT RECCOMENDED.QUICK CONNECT ALLOWED.OEM PUMPS ONLY.NO REMOTE PUMPS.NO STEERING QUICKNERS ALLOWED.ALL STEERING COMPONENTS MUST BE OEM

10.  Locked rear end OK! May use 9 inch Ford.NO FLOATER SPOOLS ONLY.DISC BRAKES ALLOWED OEM SIZE ONLY.SINGLE BRAKE MASTER ONLY.ALL 4 BRAKES MUST WORK.BRAKE HATS ALLOWED ON REAR ONLY.NO LIGHT WEIGHT ROTORS.GM REAR ENDS MUST USE C CLIP ELIMINATERS.

11.  TIRES,8 INCH WHEELS.MOD TAKE OFFS OR DOT ONLY.970.S ARE ALLOWED.MUST FIT TIRE HOOP

12.  * Racing springs and shocks allowed. No Heims on shocks, must be stock-type only, in STOCK LOCATION.NO LEAF SPRING SHACKELS OR ADJUSTABLE BUCKETS

13. Center dumps allowed on exhaust. CAST IRON exhaust manifolds ONLY. Maximum 2.5 inch pipe.NO FACTORY TUBE HEADERS ALLOWED.

14. 1 12 volt battery only.FUEL CELLS ENCLOSED IN STEEL CAN MANDANTORY.IF IT DONT SAY YOU CAN THEN DONT DO IT. 

E-Mail us at:  rvracing@yellville.net

* Changes2010-2011 RULES